1) Regeneration fuel: a combination of hydrogen and glove box manufacturers inert gasoline (hydrogen accounts for 5% -10%)

two) Amount: 40L gasoline cylinder 10Mpa

3) Regenerative fuel strain: .05Mpa (the gas usage per half hour in the state of .05Mpa is that the cylinder pressure drops by one.5Mpa. If it exceeds one.5Mpa, the tension of the strain regulator’s program will be lessened, if it is a lot less than one.5Mpa Improve the force of the pressure regulator plan)

4) System: 3 hrs heating-3 hrs heating and air flow-three hrs vacuuming-one hour pumping-10 several hours cooling

5) Techniques:

① Join the regeneration gas (check out the pipeline for leaks just after relationship: right after connecting, open up the key valve of the tension lessening valve to the maximum, open up the auxiliary meter to .1Mpa, convert off the most important valve, wait around 15 minutes, if the strain of the auxiliary meter continues to be at .1 Mpa stays unchanged, indicating no air leakage

>②Set the force of the auxiliary gauge of the pressure cutting down valve to .1Mpa (the pressure throughout air flow is about .06-.08MPa

>③ Shut the cycle and analyz

/>④Turn on the vacuum pu

/>⑤ Commence regenerat

/>⑥ The new software ends at 20h (cleanse ahead of cleansing, water and oxygen index <200p

r />6) Note: Do not cut off the power and gas during the regeneration process (especially the first 6 hours)! Some pressure reducing valves are not allowed, and the pressure needs to be adjusted appropriately to ensure continuous ventilation for 3 ho

r />7) Observation: whether the regeneration gas flowmeter shows about 20L / min, otherwise adjust the pressure of the pressure reducing valve.